Novell OPEN ENTERPRISE SERVER 2 SP2 - LINUX TIPS FOR NETWARE ADMINISTRATORS Manual page 41

NetWare Command Purpose or Subcommand
SEND Send messages to NCP
users by username or
connection number.
Get the serialVersionUID
SERIALVER
for one or more classes in
a form suitable for copying
into an evolving class.
SERVER Start and run NetWare on
the server.
Register, unregister, start
SERVERTOOL
up, and shut down a
persistent server.
SET View and configure
operating system
parameters.
Linux Command
Alternatives and Notes
Counterpart
ncpcon send For NCP connections, the send
command only sends messages to
connections (stations), not to
usernames.
Also keep in mind that users
attached through Samba/CIFS or
some other protocol do not receive
messages unless they also have an
NCP connection.
For more information about sending
messages using
"Sending Messages to Logged-In
Users" in the
Server for Linux Administration
Guide.
For more information about sending
messages using Novell Remote
Manager, see
to Logged-In
SP2: NCP Server for Linux
Administration
For more information, see the
serialver
serialver
— This is roughly equivalent to the
running the Linux kernel. There is
no direct equivalent.
OES-Linux boots using the GRUB
boot manager. There is no direct
connection between Linux and a
bootable DOS partition (if present)
For more information, see the
servertool
servertool
— There is no direct equivalent of the
concept of SET parameters in
Linux.
You can set environment variables
using the
more information, see the
man page.
To make configurations persistent,
you must edit the configuration file
associated with the service.
ncpcon , see
OES 2 SP2: NCP
"Sending Messages
Users" in the OES 2
Guide.
man page.
man page.
export command. For
export
NetWare/Linux Command Map 41