Table of Contents
Advertisement
Configuring the SUSE Linux Enterprise Server Starter
System for System z
The starter system is almost completely configured, however some information about your
local network needs to be supplied in order to properly connect and be usable.
If you are continuing immediately after installing the code, skip to "Configuring Network
Connectivity to the Starter System" If you need to set up the environment following an
interruption, follow these steps:
LINK NOVSTART 191 F191 MR
LINK NOVSTART 150 F150 MR
LINK NOVSTART 151 F151 MR
LINK NOVSTART 19F F19F MR
Figure 30. Linking the NOVSTART Minidisks On Another Userid
Configuring Network Connectivity to the Starter System
The starter system uses a simplified form of network configuration based on a CMS file.
The starter system reads this file when the system is initialized and uses it to COUPLE
the network adapter to the correct VSWITCH or guest LAN and provide network parame-
ters to the Linux IP stack.
To configure network connectivity for the starter system virtual machine, perform these
steps:
22
Installing the SUSE Linux Enterprise Server Starter System for System z
1. Ensure that the NOVSTART userid is not logged on to z/VM.
2. Log into any other z/VM userid via a tn3270 session.
3. Link the NOVSTART minidisks by typing:
1. Access NOVSTART 191 as filemode A by typing: ACCESS F191 A
2. Edit NETWORK PARMS A using XEDIT by typing: XEDIT NETWORK PARMS A. The
file should appear similar to Figure 31 on page 23.
The Sample XEDIT Profile on NOVSTART Uses Different Defaults
Note that the PROFILE XEDIT file on NOVSTART 191 (accessed as F191 in
the above step) changes the default appearance of XEDIT. Moving the XEDIT
prefix area to the right side allows easier updating of the important parts of the
file without having to skip over the prefix area when moving the cursor.
Advertisement
Table of Contents
