Table of Contents
Advertisement
Location
Section 7.8, "Configuring Multipath I/O
for the Root Device," on page 69
Section 7.11, "Scanning for New
Partitioned Devices without Rebooting,"
on page 73
Section 7.11, "Scanning for New
Partitioned Devices without Rebooting,"
on page 73
A.6.2 Managing Software RAIDs 6 and 10 with mdadm
The following change was made to this section:
Location
Section 10.4, "Creating a Degraded
RAID Array," on page 96
A.6.3 Mass Storage over IP Networks: iSCSI
The following changes were made to this section:
Location
Section 13.3.1, "Using YaST for the
iSCSI Initiator Configuration," on
page 125
A.7 May 21, 2009
Updates were made to the following section. The changes are explained below.
Section A.7.1, "Managing Multipath I/O," on page 140
Change
Added
Step 4 on page 70
and
Z.
Corrected the syntax for the command lines in Step 2.
Step 7 on page 73
replaces old Step 7 and Step 8.
Change
To see the rebuild progress while being refreshed every
second, enter
watch -n 1 cat /proc/mdstat
Change
Re-organized material for clarity.
Added information about how to use the settings for the Start-
up option for iSCSI target devices:
Automatic: This option is used for iSCSI targets that
are to be connected when the iSCSI service itself starts
up.This is the typical configuration.
Onboot: This option is used for iSCSI targets that are to
be connected during boot; that is, when root (
iSCSI. As such, the iSCSI target device will be
evaluated from the initrd on server boots.
Step 6 on page 70
for System
/
) is on
Documentation Updates 139
Advertisement
Chapters
Table of Contents
Troubleshooting
