Figure 30.3 Configuring a Network Card
Changing the Configuration of a Network Card
To change the configuration of a network card, select a card from the list of the detected
cards in the YaST network card configuration module and click Edit. The Network
Address Setup dialog appears in which to adjust the card configuration using the Address
and General tabs. For information about wireless card configuration, see
"Configuration with YaST"
Configuring IP Addresses
When possible, wired network cards available during installation are automatically
configured to use automatic address setup, DHCP.
NOTE: IBM System z and DHCP
On IBM System z platforms, DHCP-based address configuration is only supported
with network cards that have a MAC address. This is only the case with OSA
and OSA Express cards.
562
Installation and Administration
(page 534).
Section 29.1.3,