Installing Through Zenworks Linux Management On Oes Linux Sp2 - Novell EDIRECTORY 8.8 SP2 Installation Manual

You can use the ndsconfig utility to configure eDirectory Server after installation.
Novell Modular Authentication Service (NMAS
default, ndsconfig configures NMAS. You can also use the nmasinst utility to configure NMAS
server after installation. This must be done after configuring eDirectory with ndsconfig.
For more information on the ndsconfig utility, see
For more information on the nmasinst utility, see
on page
3.6.4 Installing Through ZENworks Linux Management on OES
Linux SP2
eDirectory 8.8 on OES Linux SP2 leverages ZENworks
distribution and deployment using the oes-edir88 channel.
For more information on ZENworks Linux Management, refer to
(http://www.novell.com/products/zenworks/linuxmanagement/index.html).
For more information on registering and updating Novell Linux products, refer to
Registration and Updates
You can install to eDirectory 8.8 on OES Linux SP2 using either of the following methods:
Through the Command Line Interface
To install through ZENworks Linux Management through your terminal, complete the following
steps:
1 Install the packages.
60 Novell eDirectory 8.8 Installation Guide
If you do not want to export the paths manually, you can use the /opt/novell/
eDirectory/bin/ndspath script as follows:
Prefix the ndspath script to the utility and run the utility you want as follows:
/opt/novell/eDirectory/bin/ndspath
utility_name_with_parameters
Export the paths in the current shell as follows:
. /opt/novell/eDirectory/bin/ndspath
After entering the above command, run the utilities as you would normally do.
The path exporting instructions should be placed at the end of /etc/profile or ~/bashrc
or similar scripts. Therefore, whenever you log in or open a new shell, you can start
using the utilities directly.
77.
(http://support.novell.com/linux/registration/).
Through the Command Line Interface
Through the GUI
1a Check if the Novell_Update_Server service exists as follows:
rug sl
1b (Conditional) If the service is not present, add it as follows:
rug sa URL_for_the_service
) is installed as part of the server component. By
TM
"The ndsconfig Utility" on page
"Using the nmasinst Utility to Configure NMAS"
®
Linux Management to provide easy install
ZENworks Linux Management
117.
Linux