Configuring The Linux Access Gateway After It Is Installed On Rhel; Configuring The New Network Interface; Section 3.8, "Configuring The Linux Access Gateway After It Is Installed On Rhel - Novell ACCESS MANAGER 3.1 SP1 Installation Manual

cd /opt/novell/access-gateway/scripts/
7 Specify the following command to run the script:
sh configure-lag.sh
8 Specify the following information for the script:
8a Specify the mount point for the Linux Access Gateway in the current Operating System.
For example, /lag.
8b Specify yes when prompted to confirm.
8c Select the device containing the / partition of the Linux Access Gateway Installation from
the list displayed. Specify the relevant number.
8d Select the device containing the /var partition of the Linux Access Gateway Installation
from the list displayed. Specify the relevant number.
8e Specify yes, when prompted to confirm mounting.
8f Verify and specify yes, when prompted to confirm
8g Specify yes to continue.
8h Specify yes to edit the syslog configuration, so the Linux Access Gateway logs to syslog.
8i Specify yes to restart the syslog daemon.
9 Start the Linux Access Gateway service by using the following command:
/etc/init.d/novell-am-gateway start
NOTE: You must close the terminal used to execute the above command.
The Linux Access Gateway service is automatically started when the machine is rebooted.
10 (Optional) If you want to stop the Linux Access Gateway service, use the following command:
/etc/init.d/novell-am-gateway stop
3.8 Configuring the Linux Access Gateway after
It Is Installed on RHEL
The Linux Access Gateway must be configured after it is installed on RHEL. For information on
configuring the gateway, see the
www.novell.com/documentation/novellaccessmanager31/accessgateway/?page=/documentation/
novellaccessmanager31/accessgateway/data/bookinfo.html).
If you want to add or modify the network configuration for Linux Access Gateway installed on
RHEL, the procedure is different from the Linux Access Gateway installed on SUSE
Enterprise Server (SLES).
Section 3.8.1, "Configuring the New Network Interface," on page 37
Section 3.8.2, "Configuring a Secondary IP Address," on page 38

3.8.1 Configuring the New Network Interface

1 Configure the network interface in RHEL by selecting System > Administration > Network.
Novell Access Manager 3.1 SP1 Access Gateway Guide (http://
Additional Information on Installing And Configuring
modifications.
fstab
®
Linux
37