Page 1
Quick Installation Guide EAP900H EAP1750H version 1.0 Ceiling Mount Design Dual Band Indoor Access Points...
Page 2
Package Contents Access Point Quick Installation Guide Power Adapter RJ-45 Ethernet Cable Minimum Requirements Broadband Internet Service (Cable or DSL Modem) Internet Browser (Internet Explorer, Safari, Firefox, Chrome)
Page 3
Connecting the Access Point A) Connect one end of the Ethernet cable into the LAN port of the Access Point and the other end to the Ethernet port on the computer. B) Connect the Power Adapter to the DC-IN port of the Access Point and plug the other end in to an electrical outlet.
Page 4
IP Address Configuration A) Once your computer is on, ensure that your TCP/IP is set to On or Enabled. Open Network Connections and then click Local Area Connecton. Select Internet Protocol Version 4 (TCP/IPv4). B) If your PC is already on a network, ensure that you have set it to a Static IP Address on the interface.
Page 5
Access Point Setup A) To configure the Access Point, open a web browser. In the address bar of the web browser, enter 192.168.1.1 and hit enter. B) A login screen will appear. By default, the username of the Access Point is admin and the password is admin.
Page 6
Switching Modes A) This device can operate in the following modes: Access Point, WDS AP and WDS Bridge. B) Select the Operation Mode under “Network”, “Wireless” tab.
Page 7
Sao Paulo, Brazil: (+55) 11 3957 0303 pg.engeniustech.com D.F, Mexico: (+52) 55 1163 8894 Netherlands Europe support@engeniusnetworks.eu (+31) 40 8200 887 www.engeniusnetworks.eu Africa Dubai, UAE support@engenius-me.com Toll Free: U.A.E.: 800-EnGenius Middle East 800-364-364-87 General: Russia (+971) 4 357 5599 www.engenius-me.com Asia Singapore www.engeniustech.com.sg/e_warranty_form techsupport@engeniustech.com.sg Oceania Toll Free: www.engeniustech.com.sg...
Need help?
Do you have a question about the EAP900H and is the answer not in the manual?
Questions and answers