Battery Compartment - Fishman PREFIX PRO BLEND Manual

Prefix -
Prefix -
Stereo Blender
Stereo Blender
3. Increase the volume some more and play (on the low E string) the fifth fret A
and above. Flip the phase switch to the position that eliminates feedback in this
region.
4. Slowly increase the Volume again, until you start to hear a high squeal.
5. Lower the Contour slider all the way down and adjust the Frequency slider until
the squealy feedback is eliminated. Raise the Contour slider (if possible) to just
below the threshold of feedback.
6. Move the Blend slider up to mix in the pickup signal (A).
7. Adjust the Bass and Treble controls as desired. Note that these controls do not
affect the microphone signal.
8. Play your guitar as loud as you like.
S
ETUP

Battery Compartment

Pull the small tab at the top of
the Onboard Blender™ toward
you. The body of the preamp
will swing out, revealing the
battery compartment. Observe
the polarity marks on the bat-
tery clip and install a fresh 9V
alkaline battery accordingly.
See diagram on page 9
4
4