Advertisement
Quick Links
Add an All-in-One Sensor to
your Home Security System
After you install your Keypad Sensor Hub, you can
use the Arlo Secure App to add All-in-One Sensors.
To install your All-in-One Sensor:
1.
Open the Arlo Secure App and tap Add Device or
+ if you have other devices.
2.
Follow the setup instructions for your All-in-One
Sensor.
Note: The sensor is for indoor use only. The
Arlo Secure App shows you how to separate
and reattach the front module from the back
housing.
Do not attach the sensor adhesive unless the app
instructs you to do so. If you're using the sensor
to detect water leaks, the adhesive isn't needed.
Advertisement
Related Manuals for Arlo SS1201-100NAS
Summary of Contents for Arlo SS1201-100NAS
- Page 1 After you install your Keypad Sensor Hub, you can use the Arlo Secure App to add All-in-One Sensors. To install your All-in-One Sensor: Open the Arlo Secure App and tap Add Device or + if you have other devices. Follow the setup instructions for your All-in-One Sensor.
- Page 2 Corner Wall Plate with Flat Wall Plate with Long Screw and Anchor Short Screw and Anchor Note: Your sensor might not need a wall plate, depending on how it will be used. The Arlo Secure App explains this during setup.
- Page 3 Need help? We are here for you. Visit www.arlo.com/support for quick answers and: • How-to videos • Troubleshooting tips • Additional support resources...
- Page 4 © Arlo Technologies, Inc. Arlo, Arlo logo, and Every Angle Covered are trademarks of Arlo Technologies, Inc. Any other trademarks are for reference purposes. Si ce produit est vendu au Canada, vous pouvez accéder à ce document en français canadien à arlo.com/docs.
Need help?
Do you have a question about the SS1201-100NAS and is the answer not in the manual?
Questions and answers