Using The Remote Control
The CR2032 lithium battery is already installed in the remote control. Pull out the small
mylar insulation tab as shown in the illustration to begin using the remote control.
To use the remote controller, point the remote control towards the remote control receiver on
the front panel of the main unit and press the desired button. The effective range of the
remote controller is approximately 20 feet. Please note that bright sunlight or artificial light
may interfere with the proper operation of the remote control.
When the remote operation becomes weak or intermittent, it is time to replace the remote
control battery. Pull out the battery holder, remove the old battery and install a new CR2032
battery in the holder as shown in the illustration. Slide the holder back into the remote
NOTE: If the battery is installed incorrectly the remote control will not work.
• Make sure that you have removed
the mlar insulation tab from the
• Ensure the system is connected to an AC outlet that is always "live".
1. Remote Control Transmitter
3. iPod MENU + Button
5. ENTER Button
6. iPod MENU - Button
7. PLAY / PAUSE
8. VIDEO OUT Button
11. MENU Button
12. 3D SOUND Button