Adsl Link Led - NETGEAR DGN2200v1 Setup Manual

ADSL Link LED

If your router is unable to access the Internet, you should first determine whether you have an
ADSL link with the service provider. The state of this connection is indicated with the ADSL link
LED.
ADSL Link LED Is Off
If the ADSL Link LED is off, disconnect all telephones on the line. If this solves the problem,
reconnect the telephones one at a time, being careful to use a microfilter on each telephone. If the
microfilters are connected correctly, you should be able to connect all your telephones.
If disconnecting telephones does not result in a green ADSL link LED the problem may be one of
the following:
• Check that the telephone company has made the connection to your line and tested it.
• Verify that you are connected to the correct telephone line. If you have more than one phone
line, be sure that you are connected to the line with the ADSL service. It may be necessary to
use a swapper if you ADSL signal is on pins 1 and 4 of the RJ-11 jack. The Modem Router
uses pins 2 and 3.
ADSL Link LED Green
If your ADSL link LED is green, then you have a good ADSL connection. You can be confident
that the service provider has connected your line correctly and that your wiring is correct.
ADSL Link LED Blinking Green
If your ADSL link LED is blinking green, then your wireless-N modem router is attempting to
make an ADSL connection with the service provider. The LED should turn green within several
minutes.
If the ADSL link LED does not turn green, disconnect all telephones on the line. If this solves the
problem, reconnect the telephones one at a time, being careful to use a microfilter on each
telephone. If the microfilters are connected correctly, you should be able to connect all your
telephones.
If disconnecting telephones does not result in a green ADSL link LED, there may be a problem
with your wiring. If the telephone company has tested the ADSL signal at your Network Interface
Device (NID), then you may have poor quality wiring in your house.
Internet LED Is Red
If the Internet LED is red, the device was unable to connect to the Internet. Verify the following:
Troubleshooting 29