Voice Dialling - Sony Ericsson W710 User Manual

Tips when recording and using voice
commands
If your phone cannot detect your voice
command, one of the following might
have happened:
•
You spoke too softly – try speaking
louder.
•
You held the phone too far away –
hold it as you do during a call.
•
The voice command was too short –
it should be around one second
long and more than one syllable.
•
You spoke too late or too soon –
speak immediately after the tone.
•
You did not record the voice
command when the hands-free was
attached – for voice control with
a hands-free kit, record when the
hands-free is attached.
•
You used another intonation –
use the same intonation as in
the recorded voice command.
To activate voice dialling and record
names
Record names using the phone,
portable hands-free, or Bluetooth™
hands-free.
1 } Settings }
the
} Voice control } Voice dialling
} Activate } Yes } New voice
and select a contact.
26 Calling
This is the Internet version of the user's guide. © Print only for private use.
General tab
2 If the contact has more than one
number, use
numbers. Select the number to add
the voice command to. Record a voice
command such as "John mobile".
3 Instructions appear. Wait for the tone
and say the command to record. The
voice command is played back to you,
if the recording quality is acceptable.
4 If the recording sounds OK to you
} } No
Yes. If not
To record another voice command for
} New voice } Add
a contact
and repeat steps 2-4 above.
Caller name
Hear your recorded contact name
when you receive a call from that
contact.
To turn the caller name on or off
} Settings }
the
} Voice control } Play caller

Voice dialling

Start voice dialling from stand-by
using the phone, a portable hands-
free, a Bluetooth headset or by saying
your magic word.
and to view the
and repeat step 3.
again
General tab
name.