Aoutside Top Exhaust; Attach Mounting Plate To Wall - GE JVM1790SK - Profile 1.7 cu. Ft. Convection Microwave Installation Instructions Manual

A
OUTSIDE TOP EXHAUST
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Install Adapter
A4. Mount Oven
A5. Adjust Exhaust Adaptor
A6. Connect Ductwork
A1.
ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach the
plate to a wall stud.
1 Remove the toggle wings from the bolts.
2 Insert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to
Installation Instructions
" onto each bolt.
3 ⁄
4
(Vertical Duct)
To use toggle bolts:
Toggle Wings
Mounting
Plate
Place the mounting plate against the wall and
3
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4 Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
12
Spacing for Toggles
More Than Wall
Thickness
Toggle
Bolt
Wall
Bolt End