Frontgate Holiday FRESHLY FALLEN SNOWCREST 169320A CLE Assembly Instructions Manual

FRESHLY FALLEN SNOWCREST 10FT FULL TREE CLEAR
PLEASE READ INSTRUCTIONS BEFORE ASSEMBLYING YOUR TREE
Your 10' Freshly Fallen Snowcrest Full Tree should contain the following:
1 Tree stand
4 Eyelet screws
If any piece is missing please contact a Frontgate Product Specialist
HOW TO ASSEMBLE AND SHAPE YOUR TREE:
1. BEFORE STARTING TO ASSEMBLE YOUR TREE, CHOOSE A LOCATION NEAR AN 110V
ELECTRICAL WALL OUTLET FOR THE PRELIT TREE.
2. REMOVE THE 4 TREE SECTIONS FROM THE TWO CARTONS.
3. THE SECTIONS OF THE TREE ARE MARKED A THROUGH D. "SECTION A" IS THE
BOTTOM, "SECTION B" IS THE LOWER MIDDLE AND "SECTION C" IS THE UPPER MIDDLE
AND "SECTION D" IS THE TOP.
4. PLACE THE TREE STAND ON A LEVEL SURFACE AND INSTALL THE BOTTOM END OF
THE LOWER "SECTION A" INTO THE STAND. HOLD THE SECTION IN A LEVEL POSITION
AND TIGHTEN THE FOUR SCREWS IN THE STAND AGAINST THE TREE TRUNK
SURFACE. MAKE SURE THE SCREWS ARE TIGHTENED AS EVENLY AS POSSIBLE
MAINTAINING A SNUG AND SECURE POSITION.
5. PLUG THE BOTTOM OF "SECTION A" PLUG INTO THE REMOTE RECIEVER AND THE
REMOTE RECIEVER INTO THE WALL OUTLET.
F R O N T G A T E
Holiday Collection
(169320A CLE & 169320B CLE)
ASSEMBLY INSTRUCTIONS
(4 SECTIONS WITH 1 EXTENSION CORD)
Accessory kit
4 Tree sections labeled A, B, C, D
1 Remote control with receiver
**Battery not included for Remote. Battery needed is 12 Volt, 23A**
®