Voltage Selector - Fishman ACOUSTIC PERFORMER PRO Manual

A C O U S T I C P E R F O R M E R
R E A R P A N E L - P O W E R S E C T I O N

VOLTAGE SELECTOR

The Voltage Selector switch provides the option of powering the Acoustic Performer Pro
with either 115 volts AC or 230 volts AC. You must use a cord with the appropriate plug
configuration for the AC (mains) receptacles in the area in which you use it. If you are tak-
ing the Acoustic Performer Pro overseas, check with your dealer regarding the appropri-
ate cord and plug configuration, or contact Fishman Customer Service.
ON/OFF SWITCH
The Acoustic Performer Pro's Power Switch has a "I" symbol for On and a "0" symbol for
Off. Always turn the Acoustic Performer Pro off before unplugging it.
AC POWER RECEPTACLE
Plug your AC (mains) power cord into this receptacle and the other end into a grounded
outlet. Do not modify the cord in any way. Do not cut off the grounding pin, and never use
a 3-pin-to-2-pin adapter unless you ground the adapter's grounding tab. If you use an
extension cord, always use a heavy-duty cord that is no longer than necessary.
NOTE: If your AC (mains) cord is ever damaged or lost, replace it only with the same
type.
CHANGING THE FUSE
The Fuse Holder is located to the left of the AC Receptacle (See Page 4, Item
#12). It is designed to hold a spare fuse. Insert a small screwdriver into the small
notch on the side of the Fuse Holder to remove it from the AC Receptacle. DO
NOT use a knife or sharp object. After replacing the fuse, slide the Fuse Holder all
the way into the Back Panel until it snaps into place.
IMPORTANT:
When operating in the United States, always set the Voltage
Selection switch for 115V using a 5 Amp Slow Blow Fuse. In Europe, set for 230V
with a 2.5 Amp Slow Blow Fuse.
P R O
18