How To Use; Cleaner Description - Maytag CYLINDER CLEANER Manual

Attach hose, wand, tools and nozzle
B
C
10
11
12
13
14
15
4
A
9
8
7
6
4
5
3
2
1
Attach hose
1-2
Insert hose connector (A) into opening (B) in bag lid, align-
ing tabs on hose connector with slots in opening. Twist
counterclockwise to latch.
To remove hose, twist hose connector clockwise and pull
up.
1-3 Attach wand
To attach wand to hose, push wand firmly onto hose; twist
wand to tighten.
To adjust the telescoping wand, push spring latch (C) and
pull down on lower portion of wand. Adjust wand to
desired length. Release latch to lock the wand in
position.
1-4 Attach tools and nozzle
To attach tool to the hose or wand, firmly push tool onto
hose or wand. Twist tool slightly to tighten or loosen con-
nection.
To attach either nozzle to the wand, push the nozzle firmly
onto the wand. Twist nozzle slightly to tighten or loosen
connection.

2. How to use

Cleaner description

Use the following to identify the parts and
2-1
features of the cleaner:
1. Turbine nozzle
2. Bag lid
3. Bag lid latch (on rear of cleaner)
4. Wand storage/tool storage slot (at rear of
carrying handle)
5. Combination tool
6. Crevice tool
7. Dusting brush
8. Wand/tool storage holder: fits into storage
slot on rear of carry handle
9. Hand grip
10. Hose
11. Spring latch
12. Carrying handle
13. Hose connector
14. ON/OFF switch
15. Telescoping extension wand: used with
turbine nozzle, floor brush or tools.
Adjusts to desired length.
Operate cleaner only at voltage specified
on data plate on underside of the cleaner.
This cleaner is intended for household use.