Filter; Lubrication - Maytag CYLINDER CLEANER Manual

3-4 Close bag lid, making sure bag is completely
inside bag compartment.
Close and latch bag lid.
Secondary filter
Disconnect cleaner from electrical outlet.
The secondary filter, located in the bag compartment, pro-
tects the motor from dirt particles.
To replace the filter when it becomes dirty, remove the dis-
posable bag, following Figs. 3-1 and 3-2.
Grasp the centre of the filter retainer (A) and pull
3-5
up to remove. DO NOT DISCARD filter retainer.
Remove the used secondary filter (B) and discard.
3-6
Replace with a new filter. Put the filter retainer back
into position and press in place.
Replace the disposable bag (Figs. 3-3 and 3-4), close bag
lid and latch.
Do not operate cleaner without secondary filter and dis-
posable bag in place.
It is recommended that the secondary filter be replaced after
every 2 bag changes. Disposable bags and filters may be
purchased from your local Maytag retailer. When ordering,
be sure to give the model number of your cleaner. Ask for
Maytag part number 401011CB.

Lubrication

The motor is equipped with sufficient lubrication for the life of the motor. The addition of lubricant could cause
damage.
Therefore, do not add lubricant to the motor.
B
)
(Cont'd
A
7