Table of Contents
Advertisement
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for each of the four
IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide successively
increased performance. In Auto mode, the system automatically determines the best mode for each
device. The settings are: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
Primary/Secondary Master/Slave UltraDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating
environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If
your hard drive and your system software both support Ultra DMA/33 and Ultra DMA/66, select Auto
to enable BIOS support. The settings are: Auto, Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If your
IDE hard drive supports block mode (most new drives do), select Enabled for automatic detection of
the optimal number of block read/writes per sector the drive can support. The settings are: Enabled,
Disabled.
3-7-2 OnChip Device Function
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
AC97 Audio Device
Game Port Address
Midi Port Address
Midi Port IRQ
AC97 Modem Device
USB Device Function
USB Keyboard Legacy Support
Onboard LAN Boot ROM
ETHERNET Address ID Input
SiS180 SATA Controller
↑ ↓ → ←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
AC97 Audio Device
This will determine which on Board AC97 Codec Function will use. The settings are: Enabled,
Disabled.
Game Port Address/Midi Port Address
This will determine which Address the Game Port/Midi Port will use.
USB Device Function
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have a
USB peripherals. The settings are: Enabled, Disabled.
USB Keyboard Legacy Support
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have a
USB keyboard. The settings are: Enabled, Disabled.
SiS180 SATA Controller
The settings are: Enabled and Disabled
3-7-3 Onboard Super IO Function
OnChip Device Function
Enabled
201
10
Enabled
Enabled
Disabled
Disabled
Press Enter
Enabled
F6:Optimized Defaults
27
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults
Advertisement
Table of Contents
