Interrupt Request Table For This Motherboard; Pci-Express Slot - JETWAY 939GT4SLIR311 User Manual

2-5-3 Interrupt Request Table For This Motherboard

Interrupt request are shared as shown the table below:
Slot 1
Slot 2
Slot 3
Onboard USB 1
Onboard USB 2
AC97/MC97
IMPORTANT! If using PCI cards on shared slots, make sure that the drivers support
"Shared IRQ" or that the cards don't need IRQ assignments. Conflicts will
arise between the two PCI groups that will make the system unstable or
cards inoperable.
2-5-4 PCI Express Slot
This motherboard provides three 16-lane PCI Express slot intended for Graphics Attach(Two
symmetrical PCI-Express x16 graphics slots in light green deliver up to 2Gbyte/sec data
transfer rate at each relative direction which is fully compatible with the latest NVIDIA SLI
Technology. One PCI-Express x16 graphics slot offers 4Gbyte/sec data transfer rate at each
relative direction.), and one x1 PCI Express Slot. Fully compliant to the PCI Express Base
Specification revision 1.0a , support PCI Express VGA card, and other PCI Express device.
IMPORTANT! Please make sure the major display output is out from the NVIDIA SLI
Supported VGA Card installed in the 2
in light green while activating the SLI technology with one pair NVIDIA
SLI Supported VGA Cards . And install the single PCI EXPRESS x16
interface supported VGA card to get the full speed of x16 bandwidth in
the PCI EXPRESS x16 slot in light yellow as being marked above.
INT A INT B INT C
SLI VGA Signal Output
12
INT D INT E INT F
nd
PCI EXPRESS x8 for SLI slot
INT G INT H
PCI-E x1 Slot
st
1 PCI-E x8 for SLI
PCI-E x16 for full bandwidth
nd
2 PCI-E x8 for SLI