JETWAY 917PDCP User Manual page 26

(11) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(12) Primary IDE Connector (40-pin block): IDE1 (Support ATA 100)
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
(13) Secondary IDE Connector (40-pin block): IDE2 (Support ATA 133)
This connector connects to the next set of Master and Slave hard disks. Follow the same
procedure described for the primary IDE connector. You may also configure two hard
disks to be both Masters using one ribbon cable on the primary IDE connector and another
ribbon cable on the secondary IDE connector.
Line-IN
PS/2
PRINT
Mouse
COM1
PS/2
Keyboard
FDD
Floppy Drive Connector
IDE2
Pin 1
23
Line-OUT
Surrback
VGA
USB2
GEN/LFE
Pin 1
IDE1
LAN
USB
MIC-IN
SURROUND
Pin 1