Advertisement
NOTE: For 802.11b and 802.11g mode, the signals can be transmitted
only by antenna 1 (The antenna on the right side of the rear panel).
For 802.11n mode: The Smart Repeater is operating in a 2T3R Spatial
Multiplexing MIMO configuration. 2 antennas are for signal
transmitting and 3 antennas are for signal receiving.
ESSID (3):
Channel Number (4): Please select a channel from the dropdown list of
Associated Clients (5): Click 'Show Active Clients' button, then an "Active
NOTE: If you don't have special reason to limit the type of allowed
wireless clients, it's recommended to choose '2.4 GHz (B+G+N) to
maximize wireless client compatibility.
This is the name of wireless Smart Repeater. You can
type any alphanumerical characters here, maximum 32
characters. ESSID is used to identify your own wireless
Smart Repeater from others when there are other
wireless Smart Repeaters in the same area. Default
SSID is 'default', it's recommended to change default
ESSID value to the one which is meaningful to you, like
myhome, office_room1, etc.
'Channel Number', 1 to 11 for USA. (This product is only
for use in the USA and is restricted to usage of the channels
1-11 only)You can choose any channel number you
want to use, and almost all wireless clients can locate
the channel you're using automatically without any
problem. However, it's still useful to remember the
channel number you use, as some wireless clients
support manual channel number selecting, and this
would help in certain scenarios when there is some
radio communication problems.
Wireless Client Table" will pop up. You can see the
status of all active wireless stations that are connecting
to the access point.
56
Advertisement
