Download Print this page

DYNATEK DFCH-5 User Manual

Fi controller

Advertisement

Quick Links

2002-2005 Harley Davidson
Congratulations on your purchase of this Dynatek product.
Please take a moment to read these instructions completely before
installing the FI controller. The installation will only take a few minutes,
but proper setup for your specific bike will take longer
Parts List
FI Controller
Installation Guide
Wire tap
Wire ties
Velcro
Strip
®
Alcohol Swab
Dynatek • 164 S. Valencia St. Glendora CA 91741
V-Rod Models
Part Number DFCH-5
User Manual
www.dynaonline.com
2801190
REV. 8-11-05
800.928.3962

Advertisement

loading
Need help?

Need help?

Do you have a question about the DFCH-5 and is the answer not in the manual?

Questions and answers

Summary of Contents for DYNATEK DFCH-5

  • Page 1 FI controller. The installation will only take a few minutes, but proper setup for your specific bike will take longer Parts List FI Controller Installation Guide Wire tap Wire ties Velcro Strip ® Alcohol Swab www.dynaonline.com Dynatek • 164 S. Valencia St. Glendora CA 91741 800.928.3962...
  • Page 2 FIC harness, locate the black wire with with the ring terminal. This needs to be grounded to the bolt that is on the front cylinder head. Use a wire tie to secure the FIC harness to the stock wiring harness. Ground Part# DFCH-5...
  • Page 3 Once all of the injector wires are connected, gently pull the extra slack in the harness back through the left side of the bike.The yellow wire with the green stripe on the stock harness should connect to the red wire on the FIC harness. Part# DFCH-5...
  • Page 4 Plug the grey wire from the FIC harness into the wire tap on the TPS connector. STEP 9 Reinstall airbox and breather hose. Reinstall airbox lid. Reconnect temp sensor at front of airbox. Reinstall airbox cover, and seat. Part# DFCH-5...
  • Page 5: Troubleshooting

    To add fuel, turn the potentiometer clockwise. To subtract fuel, turn the potentiometer counterclockwise. With the potentiometer pointed straight up at the thick tick mark (towards the Dynatek logo), that is 0% adjustment. Fully counterclockwise is -20%, and fully clockwise is +20%. Adjusting the potentiometer...