Advertisement
Quick Links
Model 122A22
Rocket motor ICP® pressure sensor, 3000 psi, 1 mV/psi, Helium bleed,
Installation and Operating Manual
For assistance with the operation of this product,
contact PCB Piezotronics, Inc.
Toll-free: 800-828-8840
24-hour SensorLine: 716-684-0001
Fax: 716-684-0987
E-mail: info@pcb.com
Web: www.pcb.com
Advertisement
Related Manuals for PCB Piezotronics 122A
Summary of Contents for PCB Piezotronics 122A
- Page 1 Model 122A22 Rocket motor ICP® pressure sensor, 3000 psi, 1 mV/psi, Helium bleed, Installation and Operating Manual For assistance with the operation of this product, contact PCB Piezotronics, Inc. Toll-free: 800-828-8840 24-hour SensorLine: 716-684-0001 Fax: 716-684-0987 E-mail: info@pcb.com Web: www.pcb.com...
- Page 2 Returning Equipment – Following the equipment to PCB Piezotronics for these procedures will insure that your repair. User servicing or repair is not returned materials are handled in the recommended and, if attempted, may most expedient manner.
- Page 3 PCB Piezotronics, Inc. Warranty – All equipment and repair 3425 Walden Ave. services provided by PCB Piezotronics, Depew, NY 14043 USA Inc. are covered by a limited warranty Toll-free: (800) 828-8840 against defective...
- Page 4 The 122A series sensors contain a 10 micron helium The Models 122A21, A22, and A23 Sensors use low filter contained in a fitting threaded onto the helium ...
- Page 5 During in-place calibration, static methods (dead weight tester) may be used in a drift-free system by For charge output Model 122A, connect 4 ft. cable to placing the charge amplifier in "LONG TC" position. charge amplifier and switch to "long" time constant position and check for drift.
- Page 6 OPERATION MANUAL FOR MODELS 122A, 122A21, 122A22, and 122A24 HELIUM BLEED PRESSURE SENSOR CHARGE MODEL 122A OPERATION - ICP MODELS 122A21, A22, and A24 To calibrate this model, install in pressure port of dead weight tester and apply various static pressures...
- Page 7 The only maintenance possible on the probe is maintaining of insulation resistance of the Model 122A probe/cable assembly. Clean connectors with suitable solvent and dry. Contact factory for assistance should problems arise. ICP is a registered trademark of PCB Piezotronics Drawing number: 21089 Revision: NR...
- Page 10 OPERATION MANUAL FOR MODELS 122A, 122A21, 122A22, and 122A24 HELIUM BLEED PRESSURE SENSOR Test Report Helium Flow Test and Burst Test Sensor Model ________________________ S/N __________________________ Initial Calibration: Input (PSI) 1000 1500 2000 2500 3000 System Output (V) Burst Test to 5000 PSI - Failed...
Need help?
Do you have a question about the 122A and is the answer not in the manual?
Questions and answers