Sound Adjustment; Troubleshooting Guide - RCA RT1511 User Manual

6. CONNECTING TO OTHER EQUIPMENT
• Connect a 3.5mm-to-3.5mm audio cable (not included) to the LINE IN jack on the front of unit and the AUDIO
OUT/HEADPHONE jack of your portable device.
• Turn on your other equipment.This will allow your equipment's sound to play through the unit.
Press the SOURCE button to select LINE IN mode.
•

SOUND ADJUSTMENT

TO ADJUST THE MASTER VOLUME
• Press the VOLUME +/- buttons on the unit or the
VOLUME MASTER +/- button on the remote control
to adjust the level of all speakers.
• Point the remote control at the REMOTE SENSOR
located on the unit.
TO ADJUST THE VOLUME OF AN INDIVIDUAL
SPEAKER
• Directly press the + or - button on the remote control
to increase or decrease the level of the corresponding
speaker(s).
• Point the remote control at the REMOTE SENSOR
located on the unit.
TO RESET
Press the RESET button on the remote control to
•
return to factory default speaker settings.
TROUBLE SHOOTING GUIDE
No power.
• Check that the AC power cord is connected.
No sound.
• Press the VOLUME + button to increase volume.
• Ensure the MUTE button is not pressed on
the remote control.
• Ensure the SOURCE selection is correct.
No sound from one channel or unbalanced
left and right volume.
Try pressing the RESET button on remote control. If
this doesn't help, try pressing the CHANNEL button
on remote control (this will switch system between 5.1
SURROUND and STEREO modes).
• Check the speaker connections of the inoperative
channel.
• Check the speaker cord connection and speaker
location.
• Adjust individual speaker volumes.
Please visit online help at www.RCAav.com
Specifications
Power requirement
Specifications and external appearance are subject to change without notice.
Audio Cable
(not supplied)
Need more help?
: AC ~120V 60Hz
To AUDIO OUT or
HEADPHONE jack
TO CHANGE THE SPEAKER CHANNEL
• Press the CHANNELS button on the remote control
to select the listening mode. This will switch between
5.1 (SURROUND MODE) and 2.1 (STEREO with
SUBWOOFER). We recommend you leave system in
5.1 mode. The Center and Rear Surround speakers
will not be active if system is in STEREO mode.
Note:
• Surround speakers and center speaker volume
adjustments can only be made from the remote
control in 5.1 channel speaker mode, not in 2.1
channel speaker mode.
• Press the MUTE button to instantly turn off the
sound . Press it again to restore the sound.
Reversed left and right sound.
• Check the speaker connection for proper phasing.
The center speaker or the surround
speakers give no sound.
• Check the speaker connections are correct.
• The current mode does not support surround sound.
The remote control does not function.
• Remove any obstacles between the remote control
and the unit.
• Use the remote control near the unit.
• Point the remote control at the remote sensor on the
unit.
• Replace the battery in the remote control with new
one.
• If there is a clear plastic strip sticking out from the
rear of the remote control, pull it out.
Portable Audi o
EN
7