Page 1
Wide-Angle Lens User’s manual Congratulations on purchasing your new VTech product. Before using this product, please read Important safety instructions. This manual has all the feature operations and troubleshooting necessary to install and operate your new VTech product. Please review this manual thoroughly to ensure proper installation and operation of this innovative and feature-rich VTech product.
WTR’s evaluation did not identify any risk to bystanders with pacemakers from other persons using wireless devices. Electromagnetic fields (EMF) This VTech product complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user’s manual, the product is safe to be used based on scientific evidence available today.
Page 3
Connect and charge the battery Install the parent unit battery The parent unit runs on rechargeable battery or AC power. To continuously monitor your baby, keep the parent unit connected to AC power. With the battery alone, the parent unit can cordlessly run for a short time only.
Before use Note • This baby monitor is intended as an aid. It is not a substitute for proper adult supervision, and should not be used as such. Test your baby monitor You may test the baby monitor before initial use, and at regular times thereafter. Caution •...
high-pitched screeching noise from your baby monitor while positioning: Caution - Make sure your baby unit and parent unit are more than 3 feet (1 meter) apart, OR • The default volume of your parent unit is level 4, and the maximum volume is level 7. If you experience - Lower the volume of your parent unit.
Using the baby monitor ( Con’t Lullaby The baby monitor has five lullabies and four soothing sounds for you to comfort your baby. To play lullabies or soothing sounds on the baby unit: • Press on the baby unit to play lullaby. •...
Page 7
After 10 minutes of inactivity, it will dim again. Monitoring mode for VM351-2 only Every time the parent unit is turned on, it displays a baby unit in Single CAM mode. If there are two baby units in your system, you can also monitor your baby in Patrol or Split mode.
Adjust the sound sensitivity of the baby unit You can choose to hear sounds from the baby unit all the time, or to hear sounds that exceed a certain level. You can use the parent unit to adjust the microphone sensitivity of your baby unit.
Zoom You can zoom in while viewing images from the baby unit in Single CAM and Patrol mode. • Press to zoom in. • Press to move the zoomed image downward or upward. • Press to move the zoomed image leftward or rightward. •...
Using the baby monitor ( Con’t Set temperature range You can set the desired room temperature alert range. The minimum temperature can be set between 52 F (11 C) and 69 F (20 C). The maximum temperature can be set between F (21 C) and 86 F (30...
Baby unit overview Light sensor + VOL - • Press to adjust the speaker volume. Camera It determines the lullaby volume and Infrared LEDs talkback volume transmitted from Play/ Stop parent unit. • Press to play or stop lullaby on the ON/OFF switch baby unit.
Parent unit overview ( Con’t Zoom • While in a menu, press to choose an • Press to zoom in or out. item. VIEW / LCD ON/OFF • While viewing zoomed image, Microphone press and hold to move the zoomed POWER image rightward.
• Displays the baby unit number of the selected baby unit when in Split mode. Patrol mode • Displays when the parent unit is in Patrol mode. • For VM351-2 only. Split mode • Displays when the parent unit is in Split mode.
Monitoring Mode • If you have two baby units, you can select a monitoring mode (Single CAM, Patrol or Split). • For VM351-2 only. Alert Tone You can set the parent unit to beep when • the parent unit operates in low battery condition;...
Parent unit icons (Con’t) Temperature too high at CAM # The temperature detected by the baby unit is higher/ lower than the desired temperature alert range. Temperature too low at CAM # The parent unit is turning on. Powering on... The parent unit is searching for baby units.
• DO NOT immerse the parent unit and the baby unit in water and do not clean them under the tap. • DO NOT use cleaning spray or liquid cleaners. • Make sure the baby unit and parent unit are dry before you connect them to the mains again. Storage When you are not going to use the baby monitor for some time, remove the rechargeable battery from the parent unit.
® 1 (800) 8 BATTERY for information on Li-ion battery recycling and disposal bans/restrictions in your area. VTech’s involvement in this program is part of its commitment to protecting our environment and conserving natural resources. RBRC® and 1 (800) 8 BATTERY® are registered trademarks of the Rechargeable Battery Recycling Corporation.
Page 18
Mises en garde proof of purchase does not meet the terms of this limited warranty, VTech will notify you and will request that you authorize the Utilisez et entreposez le produit à une température entre 0˚ C (32˚F) et 40˚C (104˚ F).
Need help?
Do you have a question about the VM351 and is the answer not in the manual?
Questions and answers