Remove Certificate Hold Interface
Remove Certificate Hold Interface
Description
URI:
Available on: Certificate Manager or Registration Manager agent ports.
Function: Changes the status of a certificate that has been put on hold so that it is
no longer considered revoked.
A certificate can be temporarily rendered invalid --or "put on hold"-- by revoking
it with a revocation reason code of 6. If subsequent analysis reveals that the
certificate does not need to be permanently revoked, it can be made valid again
using the Remove Certificate Hold Interface.
Only agents with valid SSL client certificates can use the Remove Certificate Hold
interface.
Default Forms
There are no default forms that use this interface. The Remove Certificate Hold
Interface is usually accessed after a list of certificates currently on hold has been
generated. In the response template that displays the list, certificates on hold can be
rendered with a "Remove Certificate Hold" button next to their listing. The
displayByCert.template
Remove Certificate Hold Interface.
Request Parameters
The following table lists the parameters accepted by the Remove Certificate Hold
interface.
Table 6-31 Parameters Accepted by the Remove Certificate Hold Interface
Parameter
op
156
Netscape Certificate Management System Customization Guide • March 2002
or
/ca/doUnrevoke
/ra/doUnrevoke
Format and Description
doUnrevoke
Specifies the operation to perform. The valid value for the Remove Certificate
Hold interface is "doUnrevoke."
and
queryCert.template
create buttons that use the