Star mC-Print3 Easy Setup Manual

80878710
Introduction
This document explains the procedures for use of mC-Print3. Please store it carefully after reading it.
Check the Supplied Accessories
MCP31CB
What the utility can do

The utility can be used to change the settings of the printer and peripheral devices.
Examples) • Bluetooth® pairing
• Bluetooth settings, LAN settings
• Firmware update/diagnosis
● To use the utility, download it from the site at right.
● To perform setup using this manual, proceed to Step
In Case of Trouble
If you experience trouble with the setup procedure, refer to the Online Manual.
Place the enclosed flyer close to the printer and use it when necessary.
Installing the Printer
1
Installing the paper roll

Pull the open lever and open the printer
.
cover 
2
1
Take the slack of the paper roll before paper
setting, insert the paper roll as shown in the
illustration.
Pull the end of the paper roll out straight
and use both hands to close the printer cover
 .
3
4
Easy Setup Guide
If any of the package contents are missing or damaged, contact the dealer where the
product was purchased.
AC Adapter Power Cable*
• Memory switch changes, logo registration
• Checking if connected device supports USB PD (Power Delivery)
• Sample printing

When using a 58 mm roll, install the pro-
vided paper roll guide.
With the notch part A (triangle mark) of the
paper roll guide facing down, angle the guide
to the right and insert it
Position so that the notch part A is aligned
with the main unit rib B, then slide the guide
from the right
When the slid paper roll guide stops, stand
it up vertical
place 
 ,
To change the paper width, it is necessary
to change the memory switch setting. For
details, refer to the Online Manual.
4
*
Accessories vary depending on the region where the printer was purchased.
USB Cable Paper Roll
Paper Roll
（C-C) Guide
etc.
1
.

.
 .
B
2
A
1
 , and press until it clicks into
.
3
4
This Manual
Easy
Safety
Setup Guide
Instructions
mC-Print3 Utility Download
www.star-m.jp/mcprint-app.html
mC-Print3 Online Manual
www.star-m.jp/mcprint3-oml.html
2
Turning ON the main unit power
Place your nails into the gaps in the right and
left sides of the rear cover on the back of the
printer, and then remove the cover.
Connect the power cable to the AC adapter
 , and connect the cable connector to the
printer as shown in the illustration
the plug into the outlet  .
2
1
Press the power button 
the LED (blue) illuminates 
5
Flyer
(Q&A reference)
 . Insert
3
and confirm that
.
4