Red Hat LINUX 7.2 Reference Manual page 314

314
Hardware
Sanyo CDR-H94A
Sony CDU-535 & 531 (some
Procomm drives)
Here are some examples of these modules in use:
Table A–2 Hardware Parameters Configuration Examples
Configuration
ATAPI CD-ROM, jumpered as master on the
second IDE channel
non-IDE Mitsumi CD-ROM on port 340, IRQ
11
Three non-IDE Mitsumi CD-ROM drives using
the experimental driver, io ports 300, 304, and
320 with IRQs 5, 10 and 11
Sony CDU 31 or 33 at port 340, no IRQ
Aztech CD-ROM at port 220
Panasonic-type CD-ROM on a SoundBlaster
interface at port 230
Phillips/LMS cm206 and cm260 at IO 340 and
IRQ 11
Goldstar R420 at IO 300
Mitsumi drive on a MAD16 soundcard at IO
Addr 330 and IRQ 1, probing DMA
Sony CDU 531 at IO address 320
Most newer Sound Blaster cards come with IDE interfaces. For these cards,
you do not need to use sbpcd parameters; only use hd X parameters.
Appendix A:General Parameters and Modules
Module
sjcd.o
sonycd535.o
Example
hdc=cdrom
mcd=0x340,11
mcdx=0x300,5,0x304,10,0x320,11
cdu31=0x340,0 OR cdu31_port=0x340
cdu31a_irq=0
aztcd=0x220
sbpcd=0x230,1
cm206=0x340,11
gscd=0x300
isp16=0x330,11,0,Mitsumi
sonycd535=0x320
Note
Parameters
sjcd=io_port OR sjcd_base=io_port
sonycd535=io_port