Troubleshooting Installation On An Ibm System Z System; You Are Unable To Boot Red Hat Enterprise Linux; Is Your System Displaying Signal 11 Errors; Trouble During The Installation - Red Hat ENTREPRISE LINUX 5 Installation Manual

Table of Contents

Advertisement

Chapter 21.
Troubleshooting Installation on an IBM
System z System
This appendix discusses some common installation problems and their solutions.

21.1. You are Unable to Boot Red Hat Enterprise Linux

21.1.1. Is Your System Displaying Signal 11 Errors?

A signal 11 error, commonly know as a segmentation fault, means that the program accessed a
memory location that was not assigned to it. A signal 11 error may be due to a bug in one of the
software programs that is installed, or faulty hardware.
Ensure that you have the latest installation updates and images from Red Hat. Review the online
errata to see if newer versions are available.

21.2. Trouble During the Installation

21.2.1. No devices found to install Red Hat Enterprise
Linux Error Message
If you receive an error message stating No devices found to install Red Hat Enterprise
Linux, then there may be an issue with your DASD devices. If you encounter this error, add
the DASD=<disks> parameter to your parm file (where disks is the DASD range reserved for
installation) and start the install again.
Additionally, make sure you format the DASDs using the dasdfmt command within a Linux root shell,
instead of formatting the DASDs using CMS.

21.2.2. Trouble with Partition Tables

If you receive an error after the Disk Partitioning Setup
phase of the installation saying something similar to
The partition table on device hda was unreadable. To create new partitions it must be
initialized, causing the loss of ALL DATA on this drive.
you may not have a partition table on that drive or the partition table on the drive may not be
recognizable by the partitioning software used in the installation program.
No matter what type of installation you are performing, backups of the existing data on your systems
should always be made.

21.2.3. Other Partitioning Problems

If you are using Disk Druid to create partitions, but cannot move to the next screen, you probably
have not created all the partitions necessary for Disk Druid's dependencies to be satisfied.
(Section 17.11, "Disk Partitioning
Setup")
227

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enterprise linux 5

Table of Contents