Red Hat ENTERPRISE LINUX WS 2.1 Installation Manual page 37

Chapter 3. Installing Red Hat Enterprise Linux WS
Figure 3-8. Creating a New Partition
Mount Point: Enter the partition's mount point. For example, if this partition should be the root
•
partition, enter /; enter /boot for the /boot partition, and so on. You can also use the pulldown
menu to choose the correct mount point for your partition.
Filesystem Type: Using the pulldown menu, select the appropriate filesystem type for this partition.
•
For more information on filesystem types, see Section 3.12.5.1.
Allowable Drives: This field contains a list of the hard disks installed on your system. If a hard
•
disk's box is highlighted, then a desired partition can be created on that hard disk. If the box is
not checked, then the partition will never be created on that hard disk. By using different checkbox
settings, you can have Disk Druid place partitions as you see fit, or let Disk Druid decide where
partitions should go.
Size (Megs): Enter the size (in megabytes) of the partition. Note, this field starts with a "1" (one);
•
unless changed, only a 1 MB partition will be created.
Additional Size Options: Choose whether to keep this partition at a fixed size, to allow it to "grow"
•
(fill up the available hard drive space) to a certain point, or to allow it to grow to fill any remaining
hard drive space available.
If you choose Fill all space up to (MB), you must give size constraints in the field to the right of
this option. This allows you to keep a certain amount of space free on your hard drive for future
use.
Force to be a primary partition: Select whether the partition you are creating should be one of the
•
first four partitions on the hard drive. If unselected, the partition created will be a logical partition.
27