Red Hat DIRECTORY SERVER 8.1 - INSTALLATION GUIDE 11-01-2010 Installation Manual page 75

Directive
Port
ServerAdminID
ServerAdminPwd
ServerIpAddress
Table 5.5. [admin] Directives
5.5.5.2. Sample .inf Files
[General]
FullMachineName=
SuiteSpotUserID=
SuiteSpotGroup=
AdminDomain=
ConfigDirectoryAdminID=
ConfigDirectoryAdminPwd= Admin123
ConfigDirectoryLdapURL=
[slapd]
Description
servers should run,
Section 1.2.4,
see
"Directory Server User
and Group".
Specifies the port that
the Administration
Server will use. The
default port is 9830.
Specifies the
administration ID
that can be used
to access this
Administration Server
if the configuration
directory is not
responding. The
default is to use the
value specified by the
ConfigDirectoryAdminID
directive. See
Section 1.2.6,
"Directory
Administrator".
Specifies the password
for the Administration
Server user.
Specifies the IP
address on which the
Administration Server
will listen. Use this
directive if you are
installing on a multi-
homed system and you
do not want to use the
first IP address for the
Administration Server.
ldap.example.com
nobody
nobody
example.com
admin
ldap://ldap.example.com:389/o=NetscapeRoot
Required
No
No
No
No
About .inf File Parameters
Example
9830
admin
65