Red Hat DIRECTORY SERVER 8.1 - INSTALLATION GUIDE 11-01-2010 Installation Manual page 45

silent setup instead, and use the SchemaFile directive in the .inf to specify additional schema
Section 5.5.5.1, ".inf File Directives"
files. See
The default option is none, which does not import any data.
18. Enter the Administration Server port number. The default is 9830, but if that port is in use, the
setup program supplies a randomly generated one.
Administration port [9830]:
19. Set an IP address for the new Administration Server to use. The Administration Server uses
a web server, and this parameter is set in the console.conf file for the server. Setting this
parameter restricts the Administration Server to that single IP. Leaving it blank, the default, allows
the Administration Server to acquire any IP address.
20. Set the user as which the Administration Server process will run. The default is nobody. For
example:
Run Administration Server as [nobody]:
21. The last screen asks if you are ready to set up your servers. Select yes.
Are you ready to set up your servers? [yes]:
Creating directory server . . .
Your new DS instance 'example3' was successfully created.
Creating the configuration directory server . . .
Beginning Admin Server reconfiguration . . .
Creating Admin Server files and directories . . .
Updating adm.conf . . .
Updating admpw . . .
Registering admin server with the configuration directory server . . .
Updating adm.conf with information from configuration directory server . . .
Updating the configuration for the httpd engine . . .
Restarting admin server . . .
The admin server was successfully started.
Admin server was successfully reconfigured and started.
Exiting . . .
Log file is '/tmp/setupul88C1.log'
When the setup-ds-admin.pl script is done, then the Directory Server is configured and running.
To log into the Directory Server Console to begin setting up your directory service, do the following:
1. Get the Administration Server port number from the Listen parameter in the console.conf
configuration file.
grep \^Listen /etc/dirsrv/admin-serv/console.conf
Listen 0.0.0.0:9830
2. Using the Administration Server port number, launch the Console.
for information on .inf directives.
Custom Setup
35