Red Hat CERTIFICATE SYSTEM 8 - AGENTS GUIDE Agents Manual page 144

Chapter 9. TPS: Managing Token and Smart Card Operations
• Signing #1 - revoked
• Signing #2 - active
• Encrypt #1 - active
If Token #1 is found, then the the certificates for Token #2 are revoked and the certificates for Token #1
are reactivated. The status for the three certificates, then, is as follows:
• Signing #1 - active
• Signing #2 - revoked
• Encrypt #1 - active
Through the TPS agent's page, however, viewing Token #1 shows Signing #1 is active; viewing Token
#2 shows that Signing #1 is revoked. This is because that Signing #1 was still revoked when Token #2
was formatted, and that information was not updated when Token #1 was subsequently formatted.
To find the current status of certificates, view an active token, and list the certificates. Active tokens
always have the most current certificate status. For information on listing certificates stored on tokens,
Section 9.3.1, "Searching Tokens".
see
134