Advertisement
TYPICAL STEREO SETUP*
For (stereo) the PARALLEL
switch must be OFF (OUT).
Left Full Range
MONO MAINS & MONITORS
The PARALLEL switch
must be OFF (OUT).
Mains
Solder tinned wires 1/4"
Strip cable insulation back 3/4"
2+
2-
1-
1+
• Slip "Securing Hub" then "Cable Clamp" over cable before attaching wires.
• Connection Configuration:
Black (1+) / pos. full range mode, Low pos. Bi amp mode
White (1-) / neg. full range mode, Low neg. Bi amp mode
Red
(2+) / not used
Green (2-) / not used
• Solder wires in contacts or use hex screws provided.
Twist-Lok
Contact
Housing
Insert
(OR MONO BI-AMP)
Ch 1 Left
BRIDGE switch
must be OFF (OUT).
Ch 2 Right
Right Full Range
Ch 1 Main Mix
BRIDGE switch
must be OFF (OUT).
Ch 2 Monitor Mix
Monitors
Mains
Twist-Lok
Cable
Clamp
BRIDGE MONO
Activate the BRIDGE switch
(IN). Control the level by Ch 1
(Ch 2 does not function.)
Use either the
Bridged Twist-Lok
connector or the
binding posts. No
other connections
can be used while in
Bridged mode.
25V OR 70V DISTRIBUTION SYSTEM
15w
25V or 70V
Distribution System:
7w
Wattage of transformer (TAP)
3w
divided by total wattage
of Amp = Number of
1w
transformer/speaker(s)
that can be hooked up.
C
TYPICAL DUAL MONITOR MIX SETUP
Up to four monitors per side using 8 ohm systems
or two monitors per side with 4 ohm systems.
Securing
Hub
Ch 1 Input
To signal socket XLR or 1/4" 2 or 3 cond. shielded
PARALLEL switch OFF (OUT).
Single speaker or
system connected
in BRIDGE mode.
Minimum imp. 4
16
15w
16
8
7w
8
+
+
4
4
3w
1w
C
C
C
BRIDGE switch
must be OFF (OUT).
or
For dual monitor mix (stereo), the PARALLEL
switch must be in the OUT position (OFF).
From Mixer Monitor 2 Output
(Shielded)
BALANCED MIC/LINE
SHIELD
+POS.
-NEG.
3
SHIELD
1
3
-NEG.
2
+POS.
1
3
2
From Mixer Monitor 1 Output
2
1
SHIELD (GROUND)
- SIGNAL (BAL.)
+ SIGNAL (BAL.)
Advertisement
