Content Index 1. General Safety Instructions ..................3 1.1 SAFETY: General Safety ..................3 1.2 SAFETY: General Power Safety ................5 2. Exploded view diagram with list of items ..............6 3. Wiring connectivity diagram ..................8 4. How to connect and disconnect power cable/ connectivity cable......9 5.
IMPORTANT NOTICE FOR USE IN HEALTHCARE ENVIRONMENTS: Dell products are not medical devices and are not listed under UL or IEC 60601 (or equivalent). As a result, they must not be used within 6 feet of a patient or in a manner that directly or indirectly contacts a patient 1.1 SAFETY: General Safety...
Page 4
if all cables have been disconnected. Do not spill food or liquids on your equipment. Before you clean your equipment, disconnect it from the electrical outlet. Clean your device with a soft cloth dampened with water. Do not use liquids or aerosol cleaners, which may contain flammable substances.
Be sure to grasp the plug, not the cable, when disconnecting equipment from an electric socket. If your equipment uses an AC adapter: Use only the Dell provided AC adapter approved for use with this device. Use of another AC adapter may cause a fire or explosion.
Page 8
Description Q’ty Remark DELL deco logo Deco bezel Deco plate PANEL Screw M2*2 Key power Key funcion Key pad Middle frame Screw M2*2 Screw M3*4 For EMEA Only, Power insulate mylar not for other regions Screw M3*7 Screw M4*8 Power board...
Page 10
For replacement of power cord, connectivity cable and external power supply (if applicable), contact Dell: 1. Go to https://www.dell.com/support. 2. Verify your country or region in the Choose A Country/Region drop-down menu at the bottom-right corner of the page. 3. Click Contact Us next to the country dropdown.
NOTE: This “Disassembly and Assembly Procedures” is for EMEA only, not for other regions. Please note that Dell will deem warranty void if any disassembly is done on the monitors. Tools Required List the type and size of the tools that would typically can be used to disassemble the product to a point where components and materials requiring selective treatment can be removed.
5.1Disassembly Procedures Step Figure Remark Pull up the stand assy Remove the stand ass’y. Unscrew the 6 Remove the screws by the rear cover Philips-head Screwdriver Use scraper to insert from the bottom site and then open the rear cover...
Page 15
Remove the 2 screws Remove the on the mainframe and mainframe disconnect the cables disconnect the Remove the FFC cables mainframe Remove the mylar...
Page 16
Remove the screws on the mainboard and power board Remove the powerboard mainboard Mainboard Remove the screw on the usb board powerboard Remove the Remove the screws on middle frame the middle frame panel...
Page 17
5.2 Assembly Procedures Tighten the screws on it Assemble and middle frame Assemble boards Tighten the screws on it Assemble the mylar Connect all the cables...
Page 18
Assemble the tighten the 2 screws on mainframe the mainframe and connect the cables Assemble the rear cover tighten the 6 screws by the Philips-head Screwdriver Pull in the stand ass’y Assemble the stand ass’y...
Need help?
Do you have a question about the SE2723DS and is the answer not in the manual?
Questions and answers