Toro TimeCutter Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.

Note: Determine the left and right sides of the machine from the normal operating position.

Connecting the Battery

No Parts Required

Procedure

1. Locate the battery and negative battery cable.
2. Remove the plastic cap from the negative battery post.
3. Remove the fasteners on the negative battery cable, and use them to secure the negative battery cable to the negative battery post (Figure 1).
   
   Figure 1

1. Negative battery cable
2. Wing nut
3. Washer
4. Negative battery post cap
5. Carriage bolt
6. Negative battery post

Installing the Rear Hitch

Parts needed for this procedure:

Procedure
Install the bracket to the frame as shown in Figure 2 and Figure 3.

Setting Up the Motion-control Levers

No Parts Required

Procedure

1. Locate the motion-control levers attached, but folded down on the machine.
2. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch).
3. Raise the motion control levers to the upright position.
4. Align the holes in the motion-control lever with the holes in the control-arm shaft, and install the bolt and washer removed previously. Repeat this for both controls levers.
   Note: Hand tighten all fasteners.
5. Move the motion-control levers to the park position, raise the seat, and move the control levers back to the center position (neutral).
6. Verify that the motion-control levers are properly aligned.
   Note: Adjust as necessary. Tighten all fasteners.

Connecting the Seat Hold Bar

No Parts Required

Procedure

1. Locate the seat-hold bar on the frame of the machine.
2. Remove the fasteners.
3. Install the seat hold bar to the seat frame.
4. Secure the bar with the washer and cotter pin removed previously (Figure 4).
   
   Figure 4

1. Cotter pin
2. Washer
3. Seat
4. Seat hold bar
5. Hole for pin, seat hold bar

Checking the Mower Adjustment

No Parts Required

Procedure
Adjust the side-to-side level and the front-to-rear blade slope. Use the relevant procedures in the Operator's Manual to verify that the deck is level, and make any adjustments as necessary.

Refer to the Operator's Manual for more information.

Completing the Setup

Parts needed for this procedure

Procedure

Checking the Tire Pressure
Check the front and rear tires for proper inflation; refer to Checking the Tire Pressure in the Operator's Manual for the recommended inflation pressure.

Checking the Side-Discharge Chute
Remove the packing restraint holding the side discharge chute up and lower the chute into place.

Checking the Engine-Oil Level
Before you start the engine and use the machine, check the oil level in the engine crankcase; refer to Checking the Oil Level in the Operator's Manual.

Keep all the following items with the machine:

• Ignition key
• Hose coupling (not included in CE models)
• Operator's Manual
• Engine Operator's Manual
• View the Operator training material before operating the machine.

Register at www.Toro.com.

Documents / Resources

References

• Lawn Mowers, Golf Equipment, Landscape Equipment, Irrigation | Toro

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Toro TimeCutter Manual