Cisco 7606-S Installation Manual page 120

Installing the Air Filter Assembly on a Cisco 7609 Router and the Cisco 7609-S Router (Optional)
1
2
Insert plastic rivet through filter assembly into ventilation holes on chassis as shown. While holding the
Step 2
filter assembly and inserted rivet in place, insert the plastic fastener to the rivet.
Fully secure the thumscrews.
Step 3
Installing the Air Filter Assembly on a Cisco 7609 Router and the
Cisco 7609-S Router (Optional)
This section describes how to install the optional air filter assembly for the Cisco 7609 router and the
Cisco 7609-S router. The filter assembly is not included with the chassis or bundle configurations. The
necessary parts can be ordered at listed in
INTAKEPNL-09= be installed on the chassis. This intake panel can be identified by the two filter
assembly support loops extending from the bottom front of the panel and the thumbscrews of the front
left and right sides of the panel (see
If you are replacing an air filter and not installing a new air filter assembly, see
Note
on a Cisco 7609 Router and the Cisco 7609-S Router (Optional), page
Part Number
INTAKEPNL-09=
FLTRASSM-09=
FLTRINSERTS-09=
Perform these steps to install the new filter assembly. If INTAKEPNL-09= is already installed, skip to
Step
Remove the intake panel by unscrewing four thumbscrews (see
Step 1
Cisco 7600 Series Router Installation Guide
5-120
Filter
Thumbscrews
Table 5-1
3.
3
Plastic rivets
4 Plastic fastener
Table 5-1. The filter assembly installation requires
Figure 5-122).
Air Filter Part Numbers
Description
Replacement Intake Panel
Filter Cage Assembly, no filter inserts included
Set of five replacement air filter inserts for
FLTRASSM-09=
Chapter 5 Removal and Replacement Procedures
Replacing the Air Filter
5-124.
Figure 5-121).
OL-4503-24