D-Link DHP-301 - PowerLine HD EN Starter User Manual page 15

Section 3 - Configuration
Configure the PLC connected nodes first (the remote DHP-300
which is not connected to the PC), and configure the ETH connected
node last (the local DHP-300 connected to the PC).
Note: If you configure the ETH node first and change the Net ID or
Encryption Key, you will not have access to the PLC nodes.
To configure a DHP-300, select it and click Next to continue. If
you want to configure a node using Advance Configuration, skip
to page 18.
Click Next
This screen shows the current configuration of the DHP-300. You
can modify any of the parameters and click Next to save your
configuration.
• Net ID: Powerline network name (case sensitive).
Default is DHP-300
• Encryption Key: Powerline network password (alphanumeric).
Default is DHP-300
• Password: Configuration Assistant password (alphanumeric).
Default is admin
• Alias: Device name (case sensitive).
Default is Device 1, Device 2, etc...
Click Next
Note: Net ID and Encryption Key can be changed to prevent unauthorized access to your powerline network. Make
sure the Net ID and Encryption Key of the devices within your powerline network are the same to enable data
transmission.
D-Link DHP-300 User Manual 1