Page 1
Kerosene Forced Air Heater (120V,60Hz,Single Phase) USER'S MANUAL AND OPERATIONINSTRUCTIONS WHD-0303 WHD-0304 (135,000BTU/Hr) WHD-0305 85,000BTU/Hr) (215,000BTU/Hr) IMPORTANT: Read and understand all of the directions in this manual before assembling, starting, or servicing the heater. Improper use of this heater can cause serious injury.
All fuel storage should be in accordance with IN NON-ADEQUATELY VENTEILED ENCLOSED SPACES. federal, state, or local authorities have jurisdiction. WARNING WARNING FOR WHD-0303: Not suitable for use on wood floors or other combustible WARNING DO NOT use in home or recreational vehicles.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE Part List(WHD-0304/WHD-0305) Note: 1. WHD-0303 is fully assembled before delivery. Here as below is the part list of WHD-0304/WHD-0305 2. Save the box and packing materials for future storage. ASSEMBLING...
WARNING Operate ONLY on a stable, level surface. Use only with electrical power specified. The WHD-0303 is not suitable for use on wood floors electrical connection and grounding MUST or other combustible materials. When used, the comply with National Electrical Code – ANSI/ heater should rest on suitable insulating material NFPA 70 (USA) and CSA C22.1 Canadian...
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE MAINTENANCE AND STORAGE STEP3: • Turn the power switch to “ON” .The power For maximum efficiency and trouble-free service, indicator lamp lights on. For unit WHD-0304 follow the instructions below for maintenance. and WHD-0305, the digital display will also light on and read the room temperature .
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE AIR FILTERS PHOTOCELL Dirty air filters will cause an imbalance in the air- The photocell should be cleaned at least once per fuel mixture. The typical sign is an increase in heating season or more depending on condition.
Due to varying fuel viscosities and normal Drain Fuel Tank component wear, the pump pressure on these For WHD-0303 drain fuel through the fuel cap heaters may need to be adjusted. When the heater opening using an approved siphon. works as followings, the pressure adjustment shall be conduct accordingly.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE WIRING DIAGRAMS FEATURE FOR WHD-0303 WARNING FEATURE FOR WHD-0304/WHD-0305...
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE TROUBLESHOOTING WHD-0303 does not carry a digital display. The indicator light flashes to report failures. WHD-0304/ WHD-0305 are equipped with a digital display. Different error codes occur to report failures.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE TROUBLESHOOTING Problem Possible Cause Solution The overheat protection wire is Check and replug the wires firmly. loose. Check and remove the foreign objects.Wait for 5 The fan blade is tripped by Fan stops running.The power minuts untill the overheat protection recover(indicator foreign objects.
Need help?
Do you have a question about the WHD-0304 and is the answer not in the manual?
Questions and answers