Starting Warm Engine - Echo SRM-260 - 12-00 Operator's Manual

3. Primer - Pump Bulb.
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4. Start - Pull Rope.
Lay the trimmer on a flat clear area and pull the recoil starter
handle (D) until engine fires.
5. Open Choke - Run.
Move the choke lever to the OPEN - RUN position. Restart engine
if necessary and allow to warm up running at idle for several
minutes.

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1. Stop Switch - Start/Run. Move stop switch button (A) forward
away from the STOP position.
2. Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible
in the "Clear" fuel return line.
3. Start - Pull Rope. Lay the trimmer on a flat clear area and pull
the recoil starter handle (D) until the engine fires.
G
RASS
DANGER
T /B
RIMMER RUSH
O '
PERATOR S
C
D
A
C
C
UTTER
25
M
ANUAL