Network Communication - Coolmay L02M24R Programming Manual

Slave program
It means to communicate with the CAN port of the slave PLC through the
CAN port of this PLC, and read the 4-bit M0~M3 of the slave PLC to D0 of the
master PLC.

8.6. Network communication

Support Mitsubishi MC protocol, modbus TCP/UDP protocol and
EtherNet/IP protocol.
The network is automatically detected after power-on. When there is a
network chip, M8193=1, the network is ready.
The involved special relays, special registers, and registers used by the IP
address are as follows:
Coolmay L02 Series PLC Programming Manual
84
https://en.coolmay.com/