Installation - VINCENT SP-331 Instructions For Use Manual

Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the protective plastic
caps must be removed from all the connections
used at the rear of the unit.
RCA connections
Contacting the middle pin of the RCA plugs with
the outer ring of the RCA chassis jack may lead to
damages to the main amplifier if it is switched on!
To avoid this hazard, connect or disconnect only
in switched-off state and more than one minute
after deactivating!
Make sure that you do not mix up the analogue
inputs for right and left. The RCA plugs for these
are mostly colour coded as follows: red for the
right channel, black or white for the left channel.
Speaker cable connections
Loudspeaker Connections
The use of ready-made loudspeaker cables is re-
commended instead of connecting the cable's cen-
tral wire (strand) directly to the terminals. Banana
plugs or cable lugs ensure high security from short-
circuits and damage to loudspeakers or amplifier.

INSTALLATION

DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
1 2
O U
OUT PUT
Make sure that bare loudspeaker wires are never
able to come into contact with each other or with
the metal on the back of the housing.
Make sure that the positive and negative loudspea-
ker wires are connected correctly. You will notice a
reduced sound quality if the connections are the
wrong way round.
Only use loudspeakers with a nominal impedance
of at least 8Ω if more than two speakers will be
connected.
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
- wrong -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
- correct -
Vincent
23