Table of Contents
Advertisement
2.14 – Installing the Memory
Before attempting to install any memory, make sure that the memory you have is compatible with
the motherboard as well as the processor. For example, while PC1600 DDR modules are
compatible with all DDR based motherboards, they will not work if you are required to run the
motherboard and processor buses at 133MHz. For this, PC2100 DDR modules are required.
Critically important is whether you're using the recommended memory for the current board you
have. For this information, please check TYAN's web site at: www.TYAN.com.
The following diagram shows the types of RAM modules you may encounter.
Use only 184-pin unbuffered non-ECC memory for S2498.
Note: The Tomcat K7M has two DIMM sockets, which supports a maximum of four banks of DDR
memory (only supports 64 MB, 128 MB, 256 MB, 512MB and 1GB technologies for x8 and x16
devices.)
2.15 – Memory Installation Procedure
When you install the memory modules, make sure the module aligns properly with the memory
slot. The modules are keyed to ensure that it is inserted only one way. The method of installing
memory modules are detailed by the following diagrams.
17
http://www.TYAN.com
Unbuffered
Non-ECC
= 8 Chips
Unbuffered
ECC
= 9 Chips
Advertisement
Table of Contents
