Board Installation; Unpacking; Installation - TYAN TITAN-PRO AT User Manual

2. Board Installation

2.1 Unpacking

The mainboard package contains the following:
w S1662 Mainboard
w One IDE 40 pin cable
w Two serial cables
w One parallel cable
w One 34 pin floppy cable
w User's Manual
w Optional PS/2 mouse cable
w Optional VRM(Voltage Regulator Module)
The mainboard contains sensitive electric components which can be easily
damaged by static electricity, so the mainboard should be left in its original
packaging until it is ready to be installed.
Touch an unpainted area of the system chassis befor handling the mainboard
or any component. Doing so discharges the static charge your body may
have built.
After opening the mainboard carton, extract the system board and place it
only on a grounded anti-static surface, component side up. Inspect the board
for damage. Press down on all of the socket IC's to make sure that they
are properly seated. Do this only with the board placed on an anti-static
mat.
DO NOT APPLY POWER TO THE BOARD IF IT HAS BEEN
DAMAGED!

2.2 Installation

You are now ready to install your mainboard. The mounting hole pattern of
the S1662 matches the "Baby AT" system board spec. It is assumed that
the chassis is designed for a standard IBM XT/AT.
S1662-AT-001 http://www.tyan.com 6