Related Manuals for Spektrum SPM-1033
Summarization of Contents
Transmitter and Receiver Binding
Binding Process
Process of teaching the receiver the specific code of the transmitter.
Failsafe
SmartSafe + Hold Last
Throttle channel moves to failsafe position on signal loss.
Preset Failsafe
Set specific control surface positions for signal loss.
SAFE Failsafe
Automatically levels aircraft if signal is lost.
Testing Failsafe
Turn transmitter RF output off to test failsafe settings.
Basic AS3X+ Setup
Model Setup and Flyability
Ensure model is fully setup and flyable before continuing.
Gain Channel Assignment
Assign an empty channel for gain adjustment.
Forward Programming Access
Access Forward Programming from transmitter.
First Time Setup
Navigate Gyro Settings > First Time Setup.
Orientation Setup
Choose automatic or manual orientation detection.
Gain Channel Select Menu
Select gain channel and input type.
Gyro Response Test
Verify surface responses counteract model movements.
Basic Tuning (AS3X+ Normal Gain, No Flight Modes)
Verify Gyro Response
Check gyro response direction using Gyro Response Test.
Adjust Gain in Flight
Use gain channel to adjust gain while flying.
Tune Oscillations
Reduce gain if oscillations occur on pitch or yaw.
SAFE Setup
Forward Programming for SAFE
Access First Time SAFE Setup via transmitter.
Capture Level Flight Attitude
Position model level and capture attitude.
Assign SAFE to Flight Modes
Configure SAFE for each flight mode.
Tuning SAFE Basics
Test Flight Configuration
Test fly to verify configuration in each flight mode.
Tune Gain Values
Adjust gain values for each axis within each flight mode.
(AS3X+) System Setup
Relearn Servo Settings
Re-apply transmitter settings after external configuration changes.
SAFE/Panic Mode Setup
Configure Panic mode, Throttle To Pitch, Attitude Trim, SAFE Failsafe.
Other Settings (Forward Programming)
Factory Reset
Reset receiver back to factory defaults.
Save to Backup
Store a second model setup file for backup.
SAFE (Self Leveling) Flying Tips
Control Input Impact
Stick movement determines bank, climb, or dive.
Throttle to Pitch Angle Demand
Throttle dictates climb angle.
Differences between Self Leveling/Angle Demand and AS3X+ modes
Control Input vs. Attitude (Self Leveling)
How controls affect attitude in Self Leveling.
Throttle Impact (AS3X+)
Throttle does not affect flight response in AS3X+.
Channel Limitations
Channel Count Options
Options for managing channel limitations.
Flight Log
Hold Explanation
45 consecutive frame losses trigger failsafe settings.
Range Testing
Standard Range Test Procedure
Stand 100 feet away, test control.
Advanced Range Testing
Advanced Test Procedure
Helper positions model, observe telemetry for fades/losses.
Hand Launch Assist (HLA) Setup
Prerequisites for HLA
Complete First Time Setup, SAFE Setup, and tune flight mode.
Configure HLA Parameters
HLA Flight Mode, Threshold G's, Threshold Throttle.
Troubleshooting Guide AS3X+
Oscillation Problem
Issues causing oscillation and their solutions.
Inconsistent Flight Performance
Causes and solutions for inconsistent flight performance.
Troubleshooting Guide
Aircraft Will Not Respond to Throttle
Issues when aircraft doesn't respond to throttle but does to other controls.
Aircraft Will Not Bind
Problems encountered during the binding process.
1-Year Limited Warranty
What this Warranty Covers
Covers defects in materials and workmanship for 1 year.
What is Not Covered
Exclusions from warranty coverage.
Purchaser's Remedy
Horizon will service or replace defective products.
WARRANTY SERVICES
Inspection or Services
Process for sending the product for inspection or service.
Non-Warranty Service
Service for products not covered by warranty.
FCC Information
CAUTION: changes or modifications...
Warning about unauthorized modifications.
NOTE: This equipment has been tested...
Equipment complies with Class B digital device limits.
Compliance Information for the European Union
EU Compliance Statement
Declaration of conformity with EU directives.
WEEE NOTICE
Information on proper disposal of electronic waste.
Need help?
Do you have a question about the SPM-1033 and is the answer not in the manual?
Questions and answers