Jumper Settings; Jumper Definitions - TYAN TIGER I7501X Manual

2.2 – Jumper Settings
Jumper Function
J21 CMOS Clear
J22 External speaker header
J34 Serial Port internal header
J38 * Wake On LAN
J39 Hardware Monitor LED header(reserved)
J40 Front panel connector
J42 SMDC (Server Management Daughter Card) connector
2
J43 I C bus connector
J50 Front USB header
J53 Intel 82545EM GbE NIC 4-pin external LAN activity/link
LED header
J55 Intel 82551QM 4-pin external LAN activity/link LED
header
* WOL is only supported by LAN1 (82551, 10/100 Mbps).
2.3 – Jumper Definitions
Jumper Example
Jumper OFF – open
Jumper ON – closed
CMOS Reset (J21)
1
Clear CMOS
You can reset the CMOS settings in case an incorrect
setting causes system instability or you have forgotten
your system/setup password or have just flashed your
BIOS by using this jumper.
- Power off system, disconnect power supply from
motherboard
- Set jumper J21 to Clear CMOS
- Wait about 5 seconds
- Set jumper J21 to Normal
8
http://www.TYAN.com
Ref. Page
Page 8
N/A
Page 9
N/A
N/A
Page 9
Page 45
N/A
Page 10
Page 39
Page 39
1
Normal
(With a spare jumper cap)