Table of Contents
Advertisement
IRQ 3, 4, 5, 7, 9, 10, 11,
14, 15
DMA Channel
0, 1, 3, 5, 6, 7
Reserved Memory Size
3.14 – Boot
Options related to the Boot settings interface can be altered through the following.
Enabled
Quick Boot
Disabled
Enabled
Quiet Boot
Disabled
Add-On Rom
Force BIOS
Display Mode
Keep Current
On
Boot up Num-Lock
Off
PS/2 Mouse
Enabled
Support
Disabled
Fast
Typematic Rate
Slow
Present
System Keyboard
Unavailable
Enabled
Parity Check
Disabled
No
Boot To OS/2
Yes
Enabled
Wait for 'F1' if error
Disabled
Hit "Del" Message
Enabled
Display
Disabled
Enabled
Disabled
Interrupt 19 Capture
Boot Device Priority
Hard Disk Drives
Removable Devices
3.15 – Chipset
Options related to the chipset can be altered through the following.
Intel E7500/7501 North
Bridge configuration
Intel ICH3 South Bridge
Configuration
Intel PCI-64 Hub 2
Configuration
PCI Slot 1,2,3,4,5,6
from an add-in IDE controller card.
These settings enable you to set which IRQs will be reserved for
other devices other than the ones that use them by default.
These settings enable DMA channel 0 and 1 to be available or
reserved.
Disabled 16K 32K 64K Size of memory block to reserve for
legacy ISA devices
When set to Enabled, some self-tests will be skipped
during POST.
If set to Enabled, OEM logo will be displayed instead
of POST messages.
Leave as Default. This setting toggles the Add-On
ROM video display mode.
Specifies whether Num-Lock will be on or off during
bootup.
Toggles the use of the PS/2 mouse port.
Changes speed of key repeat rate.
Will allow continual boot even if the keyboard is not
attached.
Toggles checking of system memory for corruption.
OS/2 Compatibility mode
If Enabled, you will have to press F1 for the system to
continue booting if an error is detected during POST.
Toggles display of pressing DEL key to enter BIOS.
This option allows removable devices to act as non-
removable devices. Some SCSI RAID cards will need
this one enabled. Please refer to your SCSI card's
documentation.
1st Boot Device
Settings for boot priority. These can be
2nd Boot Device
customized depending on your
3rd Boot Device
preference.
Specifies the boot sequence for hard drive booting. This option
will show all storage devices.
Specifies the boot sequence for removable drive booting. This
option will show all removable devices.
All settings discussed in following sections.
32
http://www.TYAN.com
Advertisement
Table of Contents
