Advertisement
2.5 – Clear CMOS (JP1)
JP1
CMOS Reset
2.6 – Onboard ATI RAGE XL Graphics (JP31)
JP31
Onboard ATI RAGE XL Graphics
(OPEN)
Normal (default)
You can reset the CMOS settings in case an
incorrect setting causes system instability or
you have forgotten your system/setup
password or have just flashed your BIOS by
using these jumpers.
Power off system and disconnect the AC
power from the power supply.
Set jumper JP1 to Clear CMOS.
Power system on and wait for the screen
to show this message: "CMOS Settings
Wrong, CMOS Checksum Bad". Now the
CMOS is cleared.
Power off system and disconnect the AC
power from the power supply and set
jumper JP1 to Normal (OPEN) for normal
operations.
Power system on and go to BIOS Setup.
Load and save setup defaults.
(OPEN)
Enabled (Default)
OPEN: The jumper enables the onboard ATI
RAGE XL graphics controller. You can also use
the onboard video in conjunction with another
PCI graphics card for multiple monitor support.
CLOSE: The jumper disables the onboard ATI
RAGE XL graphics controller.
11
http://www.tyan.com
(CLOSE)
Clear CMOS
(CLOSE)
Disabled
Advertisement
