Pnp/Pci Setup - TYAN TIGER 230 Manual

(continued from previous page)
Soft-Off by PWRBTN
Wake Up Events (subscreen)
VGA
LPT & COM
HDD & FDD
PCI Master
Wake Up on LAN / RING
RTC Alarm Resume
Date / Time
Primary INTR
IRQs Activity Monitoring
(subscreen)
3.7 PnP/PCI Configuration
This section describes the PCI/PnP configuration options available.
PNP OS Installed
Reset Configuration Data
Resources Controlled By
(ESCD)
IRQ Resources
DMA Resources
(continued on next page)
Tiger 230 S2507
Sets time needed to hold down the power button to shutdown
the system. [Default setting is Instant-Off]
Lets you enter the screen for configuring wake up events.
Sets video activity as power management event. [Default is Off]
Sets LPT and COM/Serial Port activity as power management
events. [Default is LPT/COM]
Sets floppy and HDD activity as power management events.
[Default is ON]
Sets PCI activity as power management events. [Default is Off]
Sets Wake Up on LAN / Ring as power management events.
[Default is Disabled]
Sets RTC Alarm as a power management event. [Default is Dis-
abled]
Sets Date and Time that system will wake up. [Default is 0]
Sets whether IRQ activity should be a power management
event. [Default is ON]
In this screen, you can assign how power management will
monitor each IRQ.
Sets whether the system is using a Plug-n-Play OS. [Default set-
ting is NO]
Sets whether the configuration data in the ESCD should be
reset at bootup. [Default setting is Disabled]
Sets how the PnP devices will be controlled. [Default is
Auto(ESCD)]
Sets IRQs PnP control statuses.
Sets DMAs PnP control statuses.
35