Connecting The Power Supply - TYAN TIGER 200 User Manual

2.13 Connecting the power supply

This motherboard requires an ATX power supply. Tyan recommends using one that conforms to industry
standard Revision 2.01. The images below show the ATX power connector before (Figure 2.8a) and after
(Figure 2.8b) it has been plugged in. The clip on the power connector should lock over the tab on the
onboard connector. You shouldn't be able to plug the power connector in any other way but just to be
safe, make sure it looks like Figure 2.8b. Make certain that you do not miss connecting any of the pins
because if you do, you will void your warranty and possibly cause damage to yourself and/or your moth-
erboard when the power is turned on. After connecting the power, make sure the connector is seated
firmly into its socket so it will not become loose or fall off when the computer is jostled or moved.
1 2
Figure 2.8a Figure 2.8b
You are done!
Other than checking the jumper settings and cable connections, and putting the case back on, you are
done. Installing a new motherboard may seem difficult, but by following these directions, you should have
a fairly uneventful time installing our products. If you do encounter problems, your dealer will be able to
help you, or you can consult one of our many technical support resources (see p. 7).
24
http://www.tyan.com